Butane hash oil (BHO) extraction: Difference between revisions

Line 23:

# Continue to pour butane into the tube until it runs clear.

# At this point allow most of your solvent to evaporate from the dish in the well ventilated area. Agitate occasionally.

# Once most of the solvent has evaporated pour the oil onto a parchment or slick mat and place it into the ~~vaccumm~~.

# Once most of the solvent has evaporated pour the oil onto a parchment or slick mat and place it into the vacuum.

# Turn on the vacuum and allow to reach full vacuum typically around 29 in/hg at ~~sealevel~~. The oil will begin to bubble and muffin up as the trapped butane escapes.

# Turn on the vacuum and allow to reach full vacuum typically around 29 in/hg at sea level. The oil will begin to bubble and muffin up as the trapped butane escapes.

# Wait several hours for the muffin tops to fall and the bubbles to stop forming

# Once activity has stopped place the chamber on the heat source and gently raise the temperature to 100-120 degrees. Be very careful not to add too much heat as this will burn off ~~terpines~~ and darken the product. Wait for any remaining bubbles to stop and remove from the vacuum.

# Once activity has stopped place the chamber on the heat source and gently raise the temperature to 100-120 degrees. Be very careful not to add too much heat as this will burn off terpenes and darken the product. Wait for any remaining bubbles to stop and remove from the vacuum.

# Carefully try to flip the oil and melt it into the thinnest layer possible. Again take care to not add too much heat or fold air into the product as this will add moister and trap gases which will affect the clarity and smoothness of the final product.

# place the thin layer of oil back into the chamber at full vacuum. leave over night.

@@ Line 23: / Line 23: @@
 # Continue to pour butane into the tube until it runs clear.
 # At this point allow most of your solvent to evaporate from the dish in the well ventilated area. Agitate occasionally.
-# Once most of the solvent has evaporated pour the oil onto a parchment or slick mat and place it into the vaccumm.
+# Once most of the solvent has evaporated pour the oil onto a parchment or slick mat and place it into the vacuum.
-# Turn on the vacuum and allow to reach full vacuum typically around 29 in/hg at sealevel. The oil will begin to bubble and muffin up as the trapped butane escapes.
+# Turn on the vacuum and allow to reach full vacuum typically around 29 in/hg at sea level. The oil will begin to bubble and muffin up as the trapped butane escapes.
 # Wait several hours for the muffin tops to fall and the bubbles to stop forming
-# Once activity has stopped place the chamber on the heat source and gently raise the temperature to 100-120 degrees. Be very careful not to add too much heat as this will burn off terpines and darken the product. Wait for any remaining bubbles to stop and remove from the vacuum.
+# Once activity has stopped place the chamber on the heat source and gently raise the temperature to 100-120 degrees. Be very careful not to add too much heat as this will burn off terpenes  and darken the product. Wait for any remaining bubbles to stop and remove from the vacuum.
 # Carefully try to flip the oil and melt it into the thinnest layer possible. Again take care to not add too much heat or fold air into the product as this will add moister and trap gases which will affect the clarity and smoothness of the final product.
 # place the thin layer of oil back into the chamber at full vacuum. leave over night.